4533-4P Arcade Machine | Simple User Manual

4533-4P Arcade Machine Simple User Manual

Control Panel

Quick Start:

To start playing a game, first find the category by pressing the P1_B button and continue to press it until you come to the category that you want.

Then use the joystick to navigate through the game selection screen. Push down on the joystick to move down one game at a time.

Also you can push to the right to jump through games ten at a time. Hold the joystick to the right to cycle through the games quickly.

Once you have found the game you would like to play, then press P1_A button as shown in image above.

After the game loads, press the freeplay button to add credits and then Player one start to start the game.

To exit out at any time, press and hold the player one start button and it will bring you back to the game selection screen.

Game Selection

While on the game selection screen, you can push Player1_b button to cycle through the game categories one at a time then you can push down on joystick to cycle down through game list one at a time, or press to the right and cycle through game list TEN at a time. You can also hold the joystick to the right to go through the game list superfast.

Change the orientation of the screen by hitting the all white button next to player one start that is shown here:

Once you find a game that you would like to play, push the Player1_a button to load that game.

Once the game is loaded, push the freeplay button to add credits after adding credits, push Player 1 or Player 2 start.

Exiting the Game:

While playing the game, to exit you simply hold down the Player one start button and after a few seconds it will take you back to the game selection screen.

Playing Doubles

Some games (donkey kong, pacman, galaga) require players to use the same controls. The original design of these games was based on taking turns using the same controls. As one player would play until his turn ended and then the other player would step up and take his turn on the same controls.

But if you want to play two player games with seperate controls then you would have to start it from the ends where both players are facing each other (cocktail mode).

To switch the orientation of the screen you must do it from the game selection screen by hitting the Cocktail/Standup orientation button that is shown in Figure B. This only applies if you have a cocktail table.

Volume Control

Some games may be louder than others and the volume can be adjusted to preference.

To adjust the volume you have to open up the machine and locate the amplifier that has 4 knobs on it and looks similar to the image above. Once you locate that amplifier you simply just turn the volume knob counter clockwise to lower and clockwise to raise.

Setting Up Machine to Take Quarters

Locate the coin assimulator in front of the machine and open the coin door.
Put in a sample quarter into the caddy tray as shown above in figures D and E.
Find the green QC sticker and pull up on it. It may be easier to lift up on it with the spring disconnected.
Once you have it up, then you want to put your sample quarter in the cut as shown in figure E (the yellow disc is a dummy coin that you need to replace with a real one).
After you put your quarter in the caddy, then lower it back down.

Fine tuning the coin caddy will take a number of attempts to ensure accurate alignment when it is setups correctly, then the quarter should fall all the way through.

If it gets caught then the sample quarter is not in correctly and you must hit the coin return lever to get it out and reinsert the sample quarter again.

NOTE: the machine must be on for this to work. It may take a couple of tries but it will work just keep trying!